View Single Post
Old 21st May 2018, 12:28
MartinClan's Avatar
MartinClan MartinClan is offline
Senior Member
Join Date: Sep 2004
Posts: 1,822
MartinClan is on a distinguished road

Whoever makes the propshaft should/will use a sliding joint so absolute dimensions not an issue as long as they are within the joint's range. There are a few companies out there that make custom propeshafts. Mine was made by Dave Mac. Well made and balanced although I had to ream out the centre hole on the flange at the gearbox end as, on my build (E30), this was used to centralise the propshaft.

Cheers, Robin
Reply With Quote