View Single Post
  #127  
Old 11th September 2018, 17:29
Lucky@LeMans Lucky@LeMans is offline
Senior Member
 
Join Date: Aug 2012
Posts: 2,142
Lucky@LeMans is on a distinguished road
Default

A few more jobs done. I needed to make up several curved steel tube sections to support the front end so I looked at buying a tube roller. Most of the ones I looked at that would cope with 5/8" diameter tube were too much money at £300 +. There's plenty of scrap bits of steel lying around in the garage so I've knocked up a simple one for free ! I made a couple of sets of dies so it will do flat section and tube.The first section made will go under the front edge of the scuttle, the ali being formed around it. Here are a couple of photo's...…….
Attached Images
File Type: jpg IMG_3422.jpg (88.4 KB, 124 views)
File Type: jpg IMG_3423.jpg (88.0 KB, 105 views)
File Type: jpg IMG_3424.jpg (88.0 KB, 116 views)
Reply With Quote