Thread: vortex kit
View Single Post
Old 11th September 2011, 11:49
grahamhughes grahamhughes is offline
Junior Member
Join Date: May 2011
Location: preston lancs
Posts: 20
grahamhughes is on a distinguished road

Hi Eddy
I wont have a prob with the wiring as i am an electrician. i have already removed the harness from the car labelling all the wires as i went along. As the battery is in the front of the car in the vortex i was planning on putting both the fuseboxes at the front of the car, the auxilary one(engine bay) under the bonnet and the other one behind the glovebox as in the mondeo. The only wires i would then have to extend/modify are the ones to the engine bay(Lambda sensors,airflow meter,starter motor, and the engine loom etc. I was just wondering if anybody else has used a mondeo loom and whether this was the right and best option
Regards Graham

Last edited by grahamhughes; 11th September 2011 at 15:16..
Reply With Quote