Cheers Towed, now's the time that when i finish something and it starts to resemble what i want that i feel i am getting some where with the build.
Filled and sanded the scoop and top half of the bonnet with body filler which is nearly there now so only a few slight tweaks and it will be sorted.
IMG_5060.jpg
Also copied what Paul has just done with the nose aperture blanked off with a piece of cardboard from the inside then filled in the gap to give a angled flat surface for the grill to sit against.
IMG_5062.jpg IMG_5066.jpg
A shot of both sides which have blended in quiet well, just a little more sanding to complete, most likely going to fit side leather straps to hold the bonnet down.
IMG_5063.jpg IMG_5064.jpg
I was going to fit locating pins to each edge of the bonnet but have now decide to build up a flat surface to the bonnet edge and fasten a piece of ally angle line to the top of the wheel arch for the built up flat surface to push against when the leather side straps are fastened.
Well that's it for now see you all soon.