Tear drop cover has eventually dried so gave it a covering in fiber filler.
IMG_5078.jpg IMG_5082.jpg
Once the filler has dried it's a quick sanding then body filler to smooth off the surface.
IMG_5080.jpg
Gave the bonnet built up edges a sanding until the surface was flat and parallel i may skim over with body filler.
IMG_5083.jpg IMG_5084.jpg
Cut the ally angle line that will be fastened to the top of the body wheel arch for the bonnet to clamp up against, the second image shows a strip of rubber i may use as a cushion for the bonnet lip to sit on to prevent future rubbing.
Today i have been working out how to make the boot lid stay, I'm thinking of using 6mm ally rod along with a couple of brackets made from 2mm ally sheet and a couple of pivot brackets machined from 10mm ally plate, once I've finished the boot stay ill post a few pictures hopefully in the next couple of days.
Well that's it for now see you all soon.