Sweaty Tuesday - Part 2:
As I have come up with a rather odd solution to the secure the "cut" sections along the outside edges of the grille.
This involved mixing up some bonding paste and covering the exposed edges.
( Note: I underestimated the amount of bonding paste required so I didn't complete the whole area. )
Unfortunately, as soon as I started applying the paste I started having second thoughts.
As I could feel the paste oozing in between the two layers of masking tape.
But I stuck with it and then removed the masking tape as it was starting to set hard enough.
While that was setting, I sanded down the filler on the bonnet opening.
I also sanded down the scuttle wind deflector.
Next I added some "normal" filler to the bottom lip of the bonnet opening.
I also gave a few sections of the scuttle a quick skim with the left over filler.
There was then a break from car work as I collected my Mondeo and enjoyed an air conditioned drive home.
I also racked up a load of domestic chores, where the sweat was pouring off me.
End of Part 2…