Progress is slow but sure I have finished the main interior alloy panelling the fiddly bits around the doors can't be done until the body is fitted.
[IMG]
[/IMG]
I will have to make a gearbox tunnel cover as my fibreglass one is too long too wide and too high for the new frame i'v got enough alloy sheet but no angle to make the frame doh.
[IMG
][/IMG]
The next job after that is to make a boot box in front of the tank
[IMG]
[/IMG]
Then I have to bite the bullet and cut the rear boot floor supports I've been putting this off for ages I'll have to cut about where the red line is (gulp)
[IMG
][/IMG]