Cheers Phil, whatever it is it fits and looks ok.
Just finished a few more jobs before putting the seats in.
1. Moved the fuse box as it was hanging down too far.
2. Cut an access hole in the dash to allow access to the fuse box
3. Touched up the bed liner in the foot wells.
4. Made a bracket to mount the fog lamp on the rear. its in primer just drying in the sunshine outside and will get a few coats of body colour in a minute.
5. Decided I didn't want to leave the rear of the seats in bare fibreglass so have just stone shipped the back of the first one.
6. Final fixed the runners to the drivers seats and cleaned and greased them. Had to modify the operating hand quite a bit as they are a lot closer together than they are designed to be.
Pics:
Seat before and after stone chip.
Think it looks much more "finished" now. Daft really as you will very rarely see the backs!
Pics of the runners on the drivers seat. you can see the other operating handle on the floor which give an idea of how much it had to be narrowed.
Fog lamp bracket, just about ready for top coat.
That's it for now, more a bit later hopefully!
TTFN
Mac