Wow time passes so quick since I posted any updates, still plugging away. Finally gave up on the slammed look when I altered the exhausts, have managed to cut the final one into two prong back by 10 cm and pull the tail pipes in the same making them a lot more acceptable protruding at the back, however when I pulled out of the garage I caught the rear apron on the floor ripping it up the rear seams, this was the final straw so lowering block out, with the swing Spring fitted it's still relatively low but not impracticable as before, repairs are complete, now just sanding and sanding. Got a scare reading the dangers of two pack so may take the outdoor spray route and sacrifice a little on the finish, better to be alive and see it....
|