Didn't manage to get up the man cave on Tuesday but did a couple of hours tonight.
First job was to put the 32mm holes for the master cylinders in the drivers side foot panel, quick job using the new hole saw I bought for the job, 32mm if anyone needs to know. Needed a little fettling with the half round file but I test fitted all three and they fitted like gloves.
Next I used the now obligatory PU adhesive plus 4mm X 12mm rivets to fix it to the beefy 3mm Ali angle we installed last time
You can see in this pic that when fitted the end panel actually stands off the body a couple of mm, this was intentional so give the fibreglass filler a good area to lock into.
Quick skim of the green gloop
next I turned my attention to the drivers rear cockpit corner which Dave and I panelled last time and back filled but didn't get any time to start profiling.
this is one job the air powered DA does get used for as sanding the Ali and filler down would be tedious by hand, 15 minutes later....
End of Part one