Thread: pipe routes
View Single Post
  #4  
Old 16th November 2011, 10:06
grahamhughes grahamhughes is offline
Junior Member
 
Join Date: May 2011
Location: preston lancs
Posts: 20
grahamhughes is on a distinguished road
Default pipes

Hi Ken
I have been told by Chris at vortex that if i run anything down the outside they must not protude past the outer edge of the top chassis rail as they would interfere with the body fit. He says that i must route everthing on the inside as near to the bottom rail as possible. As i understand everything has to be clipped 200mm apart to pass IVA but i cannot achieve this because of the lack of metal to fix to. I think i will run some electrical cable tray down the inside and attach the heater and aircon pipes to this
Regards Graham
Reply With Quote