Tuesday - Part 2:
I started working on the area around the tail pipe cut outs.
Whilst I fully sanded down the body work, I just gave the exhaust surrounds a light sanding.
( As these would actually look better with a bit of wear on them. )
I sanded down the return lip of the rear wheel arches on both sides.
Note:
You can see the dirt clinging to the Tetroseal I used on the inside of the rear arches.
Which ties in with
Jag's suggestion for not using it on the the inside of the bonnet.
( Especially as I still haven't fabricated any inner wheel arches for the front yet. )
It may not look it, but sanding back the area around the boot opening represents many hours of hard labour.
Unfortunately, the sun was beating down on me for most of this time and I'm slightly overcooked.
So I switched to mowing the lawn.
Which will allow me to put up the tent one of these days.
I also moved the wheels from patio to the bottom of the garden.
I've got to head out shortly this evening, so I will carry on tomorrow morning.
Until then, take care, Paul.
