Well the forum seems to be back again, so...
Sunday - Part 2
Thankfully the rain stayed away & I was able to do some bitumen painting.
I gave a second coat to the areas I had painted before going on holiday.
( Inner wheel arches, parts of the front bulk head & rear floor sections. )
I then did the lower sections of the bulk head around the mounting point.
Driver Side:
Passenger Side:
Followed by the bulk head area where I had removed part of the sill...
In the end I only prepared part of the area under the car.
It will be much easier to do the rest when the rear section is separated & turned over.
Still, it is a bit more done and every bit counts...
Finally I did one side of the parts I cleaned up.
Seat Options:
Just before I called it a night, I put my new seat in the old shell to check space.
I am slowing coming to the conclusion that I actually need different seats.
Whilst I think it might be possible to make the changes required to fit them.
It would add a lot of extra work to an already very long "To Do" list.
So it might be worth trading an extra cost for an easier build.
I will make a final decision when I see how my
Frankenstein build evolves.
Until next time, take care, Paul.