Rear bulkhead mostly fitted today ......
I rivetted some 20mm box sections to the rear of each panel to stiffen them up a bit and then glued and rivetted them in place. using some flattened aluminium angle at the base to tie it into the steel framework.
I fitted the hatch to give access to the fuel tank on the passenger side but haven't fitted the seat belt surrounds yet or the panels that will tie the rear doorshut area into the rear bulkhead ..
I am going to suggest that all the aluminium on this car is painted body colour as there is quite a bit of it and it could be overpowering if left bare ...