Pops,
I have Gary's lowering block on the back and have cut the same amount voff the front springs as Trevor did.
You have done exactly the same as me 'I cut slots in the rear for the outriggers and dropped the body until it rested on the framework, at the front it is resting on the lip in the centre..'
But I found that this looked wrong as the sides of the body were lower at the back than the front and photos of other builds look like the side edges of the cockpit should be horizontal?
So that is why I have packed the slots for the rear outriggers back out again, to lift the back so that the sides are more horizontal.
Chris
|