Thread: Ozi 206 dino
View Single Post
  #56  
Old 10th July 2016, 02:59
ozi jim ozi jim is offline
Member
 
Join Date: Apr 2015
Location: Sydney Aust
Posts: 72
ozi jim is on a distinguished road
Default

In an earlier post I made sheet metal uprights.
The rear I was happy with but the front I never was.
I could also see issues fitting the steering arm.

With the scrap from the center of the gearbox conversion plate I made 2 front uprights and I had to make caliper brackets as well.
The uprights are 5083 and the brackets are 6061 t6 .

The caliper has a S/Steel bracket to hold it to the upright,as per the sheet pattern in pic 4.

The steering arm will be sheet ,one in between the top ball joint mount and one on top.

All the radius on the edges of the uprights I did in the mill just using router bits (tungsten carbide).

P6050007.jpg

P6050008.jpg

P6050009.jpg

P6050016.jpg
Reply With Quote