The throttle peddle was the next to be sorted as I was using a Honda cable and due to where the engine sub-frame covered the original cable hole for the mini I had to re-position the hole to miss the sub-frame
As the Fibre glass was thicker than the steel firewall from the Honda I manufactured a carbon-fibre interface plate
The the peddle needed to be altered to suit the new cable position
The peddle then was warmed and bent upwards to achieve enough travel but not so the it sat above the brake peddle
The engine was refitted into the car and the cable run in
The throttle body was the fitted and the throttle was tested for full travel
All good there