|
Tribute Automotive Builds Discuss your Tribute kit build |
30th March 2016, 08:24
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
NUBODI AUTOMOTIVE Z3 Turbo Conversion
Andy (ericholm) asked about turbocharging his BMW Z3. I thought I would start a thread about the different options and potential problems.
|
30th March 2016, 08:25
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
There are kits available from the States but with shipping and fitting you will not get much change from £3500.
However there is this kit available.
http://www.ebay.co.uk/itm/BRAND-NEW-...item2c60091570
|
30th March 2016, 08:30
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
Now I've done some turbo conversions in the past. You will notice missing from the kit is the oil feed return to the sump.
The hardest part is the return. The turbo spins at very high speeds and needs a good clean oil supply flowing through the bearings which support the shaft. The outgoing oil needs to be returned to the sump. This means to do it properly the sump has to be removed and a pipe bolted or welded on. Then a quality hydraulic type hose made and fitted. You don't want this coming off or wearing through!
This is not a simple bolt on conversion like a supercharger.
|
30th March 2016, 09:57
|
Member
|
|
Join Date: Mar 2014
Posts: 54
|
|
Hi Richard,
The other conversions I found on my trawls through the tinterweb were:
GKD sports cars do a supercharger for the M42/44, bloody good price as well.
Elite developments also do an interesting turbo kit, I would have gone for it if I could have fitted an intercooler on the Kobra.
I have also found a stroker kit that will take the 2.8 out to 3.5, but I am not quite ready to mortgage my house just yet.
Lumpy.
|
30th March 2016, 10:12
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
GKD Supercharger kit is well priced but doesn't include a supercharger or updated engine management.
Still £950 for the plumbing and brackets + a few hundred for the supercharger + ?? for the engine mapping doesn't seem too bad and Superchargers are better than turbos when run with automatics I understand
|
30th March 2016, 10:17
|
|
Senior Member
|
|
Join Date: Jun 2015
Location: MK
Posts: 435
|
|
Thanks for starting the thread Richard! its going to make interesting reading I am sure.
I was reading about a kit from VF this morning thats about £4k for a supercharger for Z3 2.8/3.0 that adds approx 86bhp and can be fitted in 10-14 hours, so for me that's about 80 hours with my limited engine knowledge (Escort Mk2's mainly, from a long time ago). It also needs an ECU remap.
I like the idea that you can bolt something on to get more power, rather than major mods.
As I have changed to large wheels acceleration has deteriorated slightly, so it would be good to mitigate that with some extra power.
|
30th March 2016, 11:59
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
I saw estimates of £4-6K to supercharge mine which is what put me off.
That is why the GKD kit caught my eye. Approx : £1,000 for the kit, £500 for Supercharger, £500 for ECU and other bits. All done except the fitting for £2,000 and probably some change left over
|
30th March 2016, 13:20
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
Quote:
Originally Posted by ericholm
Thanks for starting the thread Richard! its going to make interesting reading I am sure.
I was reading about a kit from VF this morning thats about £4k for a supercharger for Z3 2.8/3.0 that adds approx 86bhp and can be fitted in 10-14 hours, so for me that's about 80 hours with my limited engine knowledge (Escort Mk2's mainly, from a long time ago). It also needs an ECU remap.
I like the idea that you can bolt something on to get more power, rather than major mods.
As I have changed to large wheels acceleration has deteriorated slightly, so it would be good to mitigate that with some extra power.
|
You may be better off with a remap, should give you 30-40BHP and more torque for £275 or less.
|
30th March 2016, 13:26
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
Quote:
Originally Posted by lumpy
Hi Richard,
The other conversions I found on my trawls through the tinterweb were:
GKD sports cars do a supercharger for the M42/44, bloody good price as well.
Elite developments also do an interesting turbo kit, I would have gone for it if I could have fitted an intercooler on the Kobra.
I have also found a stroker kit that will take the 2.8 out to 3.5, but I am not quite ready to mortgage my house just yet.
Lumpy.
|
Hi Lumpy
I have a man who wants to meet you. His name is Gaz and he runs the zroadster.org forum. He lives very close to you in Newbury. Can I pass on your number?
|
30th March 2016, 13:36
|
Member
|
|
Join Date: Mar 2014
Posts: 54
|
|
Hi Richard,
Of course you can.
Regards,
Darren.
|
30th March 2016, 13:37
|
Member
|
|
Join Date: Mar 2014
Posts: 54
|
|
lumpy<-
|
1st April 2016, 06:41
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
Just googled BMW remapping and got a link to a local company http://www.southamptonremapping.co.uk/contact.html
The website states just 10bhp and 30 tourque increase. No prices shown but I will pop down there later and ask.
I was hoping for a bigger increase than that. Any choppers anyone can recommend that will give bigger increases without blowing the car apart?
|
1st April 2016, 07:20
|
Member
|
|
Join Date: Aug 2014
Posts: 66
|
|
What about a standard m50 manifold swap? You get pretty substantial power gains. A friend of mine did it to his drifting z3, it took it from 170ish at the wheel to almost 200.
There's a good thread on it here:
http://www.bimmerforums.com/forum/sh...ld-Swap-Thread
|
1st April 2016, 07:59
|
|
Senior Member
Enthusiast
|
|
Join Date: May 2014
Posts: 607
|
|
Quote:
Originally Posted by WorldClassAccident
Just googled BMW remapping and got a link to a local company http://www.southamptonremapping.co.uk/contact.html
The website states just 10bhp and 30 tourque increase. No prices shown but I will pop down there later and ask.
I was hoping for a bigger increase than that. Any choppers anyone can recommend that will give bigger increases without blowing the car apart?
|
Thats very low figures, not sure why. Perhaps they are being conservative. My 3.0i Kali went from 231BHP to 259BHP. With the CAI and straight through exhaust it should be now 270-275BHP. However the public can't see you properly at speed so I tend to cruise around, the tart that I am!
|
1st April 2016, 08:51
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
What about a standard m50 manifold swap?
Already done that :-)
+K&N Filter and CAI
https://www.youtube.com/watch?v=fARuk-nx3Pw
Go to about 53 seconds for relative improvements
Just watched it again and realised I didn't test after the Inlet swap. Might try that today also. If the private road is still available
They quote :
Z3 2.8 24V Original 193 hp Chipped 205 hp Original 280 NM Chipped 310 NM
Z3 3.0 24V Original 231 hp Chipped 245 hp Original 300 NM Chipped 325 NM
I will be heading down shortly to talk to them. What sort of price should I be looking for?
Last edited by WorldClassAccident; 1st April 2016 at 08:55..
|
1st April 2016, 12:37
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
Interesting conversation. The Chip Kit is £225 fitted.
The 2.8 only gets about 10bhp because of the restrictive air intake system. The gains for the 2.5 and 3.0 are bigger proportionately as they are not so restricted.
My 2.8 has the air intake from a 2.5 so he reckoned it won't suffer as much so more power. Comparing number it should be 20-23bhp, maybe more with the CAI.
For easy match £225 = 22.5 extra BHP or £10 per bhp which seems quite tempting
|
1st April 2016, 16:29
|
|
Senior Member
|
|
Join Date: Jun 2015
Location: MK
Posts: 435
|
|
Hi WCA,
A K&N CAI kit is around £100 on Ebay, most forums comments seem to suggest this is the easiest gain for BHP, I guess £ for £ though the chip/remap is better value. Can't think I would just gain 10bhp for a filter change (£10/bhp), although happy for someone to tell me this is the case! haha just saw you video of the flower pot, so I get 5bhp from adding the K&N sticker, yay!
My kid brother chipped his golf and blew the engine within 5k miles as the fitter didn't make an engine mod also, so I'm nervous about just doing a chip/remap without knowing all the consequences and/or knowing someone who has had it done already and driven it around for sometime, especially for a 3.0 variant.
Cheers.
Last edited by ericholm; 1st April 2016 at 16:36..
|
1st April 2016, 17:01
|
|
Senior Member
|
|
Join Date: Apr 2013
Location: Swansea
Posts: 803
|
|
Quote:
Originally Posted by Nubodi Automotive
You may be better off with a remap, should give you 30-40BHP and more torque for £275 or less.
|
You're vastly over-selling the benefits of a remap on any un-supercharged motor there Richard.
|
1st April 2016, 17:20
|
Senior Member
|
|
Join Date: Apr 2014
Location: Midlands
Posts: 405
|
|
Quote:
Originally Posted by ericholm
Hi WCA,
A K&N CAI kit is around £100 on Ebay, most forums comments seem to suggest this is the easiest gain for BHP, I guess £ for £ though the chip/remap is better value. Can't think I would just gain 10bhp for a filter change (£10/bhp), although happy for someone to tell me this is the case! haha just saw you video of the flower pot, so I get 5bhp from adding the K&N sticker, yay!
My kid brother chipped his golf and blew the engine within 5k miles as the fitter didn't make an engine mod also, so I'm nervous about just doing a chip/remap without knowing all the consequences and/or knowing someone who has had it done already and driven it around for sometime, especially for a 3.0 variant.
Cheers.
|
Eric you're MK area if I remember right? Superchips HQ is in Buckingham and they do fitments on site there if you are concerned about the quality of the installer. But chipping it on a non turbo car gets minimal results compared to a specialist rolling road remap.
|
1st April 2016, 18:01
|
Senior Member
|
|
Join Date: Nov 2011
Posts: 3,563
|
|
chipping it on a non turbo car gets minimal results compared to a specialist rolling road remap
Guys - I might have misled you a bit by sloppy wording. £225 is for an ENGINE REMAP. I assumed this was normally achieved by replacing the standard ECU chip with a remapped one so I have been using the terms interchangeably. I might be wrong.
Also agree that turbo/supercharging gives far greater scope for turning up the power but will also need the remap/chip. The boost pressure is a big parameter in how much power you get (and engine life expectancy). Check out Mighty Car Mods to see what they do to their Honda S2000.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT +0. The time now is 06:35.
|