Yes, it opens up in another window. Sounds nice.
If you are going to run without an airbox and filters you may need richer needles. I ran a 1200 with a toledo 1300 engine swap. The air filter casing fouled the engine bay side panel so I cut away some of the box lid to clear. The extra area for air to reach the filter element in addition to coming through the normal inlet tube was sufficient to weaken the mixture when the engine was pulling hard, going uphill and also when cruising on a small throttle. It would falter slightly. Pulling out the choke a little would clear the miss and the engine would pull cleanly. Gaffer tape over the missing section gave a permanent cure!
|
Threaded Mode
