Anyone following my build will know I have put the electrics off for as long as possible - and then some!
I've now got on with it, but run into a minor issue. I wired the indicators up as per the Premier Wiring loom instructions and both sides worked.
However, I have now added a single LED warning bulb to the dash, and now I get all four bulbs flash when I indicate Left, or Right. I understand the problem is the Premier wiring loom must take the dash live supply before the outside indicator lights, rather than after. Then when I take the two separate lives to the dash bulb, it feeds back through the other side indicator circuit.
From the little I know about diodes, would one of these prevent the current passing back down the opposite circuit. If so, that should solve my problem?
If this does work,
what diode do I need?
Mike