Personal introduction and initial thoughts

[IanA]

Yes, mine is #4 of 6 built so far.

I specified a recessed front grille and to close the scoop on the bonnet (hood).

[Paul L]

More info on the Z300S here:

http://www.madabout-kitcars.com/foru...4&postcount=22

[gas guzzler]

I think mine is number 6, done in delightful battleship grey :-). Actually has an advantage I found out about this week. I was stuck in a row of traffic when a very attractive woman walking past stopped and asked if she could stroke my car as she'd not seen a matt car before. I had to bite my tongue so I didn't make a very unsuitable reply :-). As you can see mine has the side vents, did have the bonnet vent but have since filled it. Now thinking about filling the panel gaps under the vents and in front of rear wheel, also needs lowering by about 30mm (good reason not to re spray at the moment). That's the great thing about these cars, easy to personalise.
20160703_163154.jpg

Andy

[306craig]

Welcome to the site Monte. I was new to this game at Easter this year, and like you was impressed by the style of Tribute kits and the fantastic attitude of everyone on this forum. Whatever you decide to go for there will always be someone prepared to answer the most mundane or daft of questions. Good luck!

[Danny_HUFC]

Originally Posted by gas guzzler

I think mine is number 6, done in delightful battleship grey :-). Actually has an advantage I found out about this week. I was stuck in a row of traffic when a very attractive woman walking past stopped and asked if she could stroke my car as she'd not seen a matt car before. I had to bite my tongue so I didn't make a very unsuitable reply :-). As you can see mine has the side vents, did have the bonnet vent but have since filled it. Now thinking about filling the panel gaps under the vents and in front of rear wheel, also needs lowering by about 30mm (good reason not to re spray at the moment). That's the great thing about these cars, easy to personalise.
Attachment 3783

Andy

I agree with you about filling the gaps at the side skirts. Would look 100% better in my opinion.

[WorldClassAccident]

filling the gaps at the side skirts

make sure you use a flexible filler...