Hi everyone.
When fitting my engine, I noticed the small driveshaft would no way fit the gearbox due to the bending needed. This was with the engine as far right as possible. So to compensate, the engine has been tilted to bring the gearbox more in line with the hub centre line. This driveshaft is still bend a far bit.
Has anyone else had to tilt the engine for this small driveshaft?
I'm using the 220 turbo long driveshaft (outer boot died I discover today
) so will need to get this sorted or get a diesel driveshaft. But it's the short one that's worrying me.