Take one of these:
And a borrowed bare chassis, and you get:
Bit tight, touching bits of the chassis on both side:
And on the back of the engine:
After a bit of adjusting to get the driveshaft lines correct, gained a bit more clearance:
Doesn't really matter as that mount will be coming off anyway, not needed anymore.
Bit more clearance around the gearbox too now, and the driveshafts are nicely in line:
Just need to get some measurements off one of the built cars, and maybe borrow a de dion so I can check clearance around that.
But its deffo a goer now, superb