Put the body on this afternoon.
Some pics here :
http://picasaweb.google.com/kennmorton/BodyOn02
Just a couple of things not quite to plan.
After measuring all the holes needed in the body for things like seat belt anchorages on the back and steering rack spigot then ploting them on the body about the centre line and also for/aft then drilling them oversize some don't line up. The pick up points for the seat belts on top of the frame especially - one is spot on but the other is out longitudinally by about 10mm. Havn't been able to look at everything yet 'coz it was too dark by the time I finished.
How did everyone elses line up ?
One bit was my fault though - forgot about the gear lever. It managed to poke an extra hole in the tunnel, had to lift it back up and feed it through the proper hole I had so carefully cut out for it so just hope no damage done, something else to check in the daylight
Some progress to report - at last.
Threaded Mode
