There's not a lot of room to work in for this kind of job, its nearly ready to be stripped down again now i know how it all fits together, every thing is drilled and over sized bolted just to be sure it all stays together, I'm just on with building the dash and centre console, once that is fitted and I'm happy with it the strip down will begin. because i want to re paint the hole chassis again.
Last edited by artyis200; 17th November 2010 at 16:03..
finally got started on the dash board coming along nicely.the clocks are smith classics, it all pulls together nice and tight when the screws are in, iv left the main screws out for now while i make adjustments, i still have the glove box stereo and heater controls to cut out of the dash, and the junk box to cut from the centre console. not being a joiner myself i didn't realise how much work there was just to get to this stage.
Last edited by artyis200; 4th December 2010 at 14:44..
my berlinetta so far, 2lt pinto
Linear Mode
