When I was with Chris on Wednesday I noticed he had a fancy conical air filter fitted and said it sounded great. I immediately wondered if it made more power too so started to google.
Unfortunately this suggested not :
http://www.zroadster.net/forum/viewtopic.php?t=8918
But it did suggest modifying the route of the air to the air filter would improve things. Unfortunately I couldn't see any pictures on the thread and other threads I looked at didn't look the same as my engine.
Not to be put of by a lack of knowledge, guidenance or ability I made a start.
I found the bottom of the air box and pulled the connecting bit of plastic off
This was a funny shape with a sort of rectangle at the end that connected to the bottom of the air box and a flat slot at 90 degrees at the other end.
Which ever way you looked at it there seemed to be sub-optimal air flow.
What was needed here was a genius plan to use part of the existing plastic, a jubileee clip, some extra piping and my finely honed fabrication skills to get a flow of cold fresh air directly from the front of my car with no funny squidged bits.
I used a high tech computer aided design tool to generate the theoretical prototype
The yellow line shows where I should cut. The picture below shows where I actually cut.
A quick stroll over to A&E for a wash and three stiches and it looked a lot neater.
Back to the car again and I am pleased with the end result. I didn't bother refitting the bit of plastic and the end result looks like optomised air flow to me.